4-Wire Ped Head Control Unit
This is the Control Unit that mounts in the Pedestrian Signal Head (PED Head), takes power from the 120 VAC power to the walk/don't walk light signals, and operates the Push Button Station via 4 wires that connect the Control Unit to the Push Button Station. One Control Unit is required for each Push Button Station.
The accessories listed below are applicable only to the EN4. All accessories shown under the EN2 Accessories section are also applicable to the EN4 unless otherwise noted in the description. Click (here) to go to EN2 Accessories section.
4 Wire Cable 12' Long
This cable is used to connect a PHCU4W to an EN4 Push Button Station. Part number for ordering is 850-288-12
4 Wire Cable 25' Long
This cable is used to connect a PHCU4W to an EN4 Push Button Station. Part number for ordering is 850-288-25.
EZ Set Up Box for 4-Wire PBS
This Set Up Box is a tool for use in operating through all phases, one or two EN4-Wire Push Button Stations in a lab/bench top environment, without needing a Traffic Cabinet and PHCU4W. It allows easy programming of messages, or setting of configurations prior to installation on an intersection.
S03 PBS Firmware Option
This is a special firmware option applicable only to Canada. On the Part Number order sheet there is a location for this S03 option to be entered to ensure you get this option included in the EN4 Navigator PBS .
4-Wire Navigator APS System Installation Manual
This is the complete manual on the Installation of a 4-Wire Navigator System. A copy of this manual and the companion Operation Manual should be kept in the traffic signal controller cabinet.
4-Wire Navigator APS System Operation Manual
This is the complete manual on the Operation and Features of a 4-Wire Navigator System. A copy of this manual and the companion Installation Manual should be kept in the traffic signal controller cabinet.